Author Topic: MFI pressure  (Read 1489 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
MFI pressure
« on: August 05, 2023, 05:22:39 PM »
After chat with another member. I got to thinking about pressure on MFI system. I normally run around 150 at 4000 pump rpm. I do so by design. Got to wondering about smaller pumps ablity to with stand higher pressure system. I know of few who broke shafts on older enderle stuff. Most had larger pump than needed and guessing they might have broke  due to pressure cuased by jetting.

Also if have idea of safe pressure for dual gear DSR 7 gpm pump, ? Would like to know that too.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot