Author Topic: Trailer build question  (Read 4945 times)

Offline Roger

  • Full Member
  • ***
  • Posts: 185
    • View Profile
  • Your Vehicle: 125 inch Altered
Trailer build question
« on: December 19, 2019, 08:58:53 AM »
I’m needing to build a new open trailer for my racecar and want to incorporate an idea used in the video below by Jason on his trailer. The hitch/tongue tube slides into a couple of receiver tubes that appear to have adjusters welded to the four sides to adjust the horizontal & vertical clearance. If you go to time marker 2:23 on the video it shows what I’m talking about. Any idea of what the adjusters are or where I can get them?



Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Trailer build question
« Reply #1 on: December 19, 2019, 10:15:37 AM »
Can't help, but nice video
Greg
El Dorado County, CA
www.meansracing.com

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Trailer build question
« Reply #2 on: December 19, 2019, 05:46:30 PM »
Jacin's a whiz. PM him he lurks here. BTW, the '47 pickup also has a 392 Hemi.

dreracecar

  • Guest
Re: Trailer build question
« Reply #3 on: December 20, 2019, 07:47:01 AM »
Since the fit of the main tube within the receiver is rather loose, my assumption is that those are to take up the slack. Engineered to allow the hitch tube free movement sliding in and out. To build a trailer and be able to slide the tube freely, building with close tolarence's cant be done, or very difficult

Offline RacinJacin

  • Newbie
  • *
  • Posts: 40
    • View Profile
  • Your Best Time: 9.30's
  • Your Track: Thompson
  • Your Vehicle: FED
Re: Trailer build question
« Reply #4 on: January 27, 2020, 09:45:01 AM »
Hi Roger, I apologize for the delayed response.  I just sent you a PM.  I hope it was helpful.  I hope it was in time to be of some use.

Jacin

Offline Roger

  • Full Member
  • ***
  • Posts: 185
    • View Profile
  • Your Vehicle: 125 inch Altered
Re: Trailer build question
« Reply #5 on: January 27, 2020, 11:05:30 AM »
Got your PM. Thanks, will send you a PM soon:)