Author Topic: PG cooler loop line hose size  (Read 427 times)

Offline noslin

  • Full Member
  • ***
  • Posts: 169
    • View Profile
  • Your Best Time: 0.00
  • Your Engine: none
  • Your Track: none
  • Your Vehicle: none
  • General Location: west coast
PG cooler loop line hose size
« on: February 18, 2018, 09:19:56 PM »
what size hose should i get for looping the line on the cooler in/out fittings.  -6 or -4?   idea on length of hose.  figure id get a pre-made one.

Offline Paul New

  • Hero Member
  • *****
  • Posts: 532
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: PG cooler loop line hose size
« Reply #1 on: February 18, 2018, 09:22:36 PM »
Mine was -6

Offline noslin

  • Full Member
  • ***
  • Posts: 169
    • View Profile
  • Your Best Time: 0.00
  • Your Engine: none
  • Your Track: none
  • Your Vehicle: none
  • General Location: west coast
Re: PG cooler loop line hose size
« Reply #2 on: February 19, 2018, 06:18:04 PM »
Thanks Paul

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 203
    • View Profile
Re: PG cooler loop line hose size
« Reply #3 on: February 20, 2018, 07:46:43 PM »
-6 is the standard. -4would be to restrictive. If you have someone who can pull the pump and remove the bypass you can put pipe plugs in case. As far as length goes 12" would be as short as I think you get away with, without kinking it.