Author Topic: times and combos  (Read 31756 times)

Offline mfp-66

  • Newbie
  • *
  • Posts: 38
    • View Profile
  • Your Engine: stock 68 cadillac 472
times and combos
« on: February 21, 2013, 11:52:10 AM »
while i'm still putting together my car, i'm just wondering what times it will run. so it got me thinking what times others are running

so why don't you post your times, details of your car (engine, trans, rear ratio & tyre diameter) and any other info you think people might be interested in

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2058
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: times and combos
« Reply #1 on: February 21, 2013, 12:12:49 PM »
while i'm still putting together my car, i'm just wondering what times it will run. so it got me thinking what times others are running

so why don't you post your times, details of your car (engine, trans, rear ratio & tyre diameter) and any other info you think people might be interested in

Great Idea, I think it would be good to include the Time Slip for the run being disscused.
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline hotrod316

  • Sr. Member
  • ****
  • Posts: 352
    • View Profile
Re: times and combos
« Reply #2 on: February 22, 2013, 06:00:14 AM »
ours is to SLOOOOOOOOOOW TO POST

Offline Cajuninjector

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
  • Your Best Time: 7.50@176
  • Your Engine: SBC 406 Alky Stacked Hilborn
  • Your Track: SWJFA
  • Your Vehicle: 225" FED-Wizard Race Cars
Re: times and combos
« Reply #3 on: February 22, 2013, 03:46:45 PM »
406 sbc, 2-3/4 hilborn
Powerglide, 1.69 1st gear
Coan 7500 stall converter
4.30 rear gear
31x12 goodyear
7.63@173
  and want to go faster
Go Hard or Go Home

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 578
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED
Re: times and combos
« Reply #4 on: February 22, 2013, 04:44:57 PM »
Cajuninjector, thanks for your info, that's fast! Nitro? Can you share ballpark trap RPM?

Great thread!

Offline Cajuninjector

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
  • Your Best Time: 7.50@176
  • Your Engine: SBC 406 Alky Stacked Hilborn
  • Your Track: SWJFA
  • Your Vehicle: 225" FED-Wizard Race Cars
Re: times and combos
« Reply #5 on: February 22, 2013, 08:12:49 PM »
Welcome Ricardo,
No nitro, just alky. My 8th mile is around 8,500.
Go Hard or Go Home

Offline afaulk

  • Full Member
  • ***
  • Posts: 126
    • View Profile
  • Your Best Time: 4.69 @ 145 1/8 mile
  • Your Engine: 370" Blown Alky Chevy
  • Your Track: I-22 Motorsports Park, Eldridge, AL
  • Your Vehicle: 186" Faulkner FED
  • General Location: North Alabama
Re: times and combos
« Reply #6 on: February 22, 2013, 09:45:10 PM »
I'd be glad to post a time slip, if I had a printer or scanner connected to this puter.   My little car isn't that fast but it impressed me, considering the combo. 5.94 @ 117 eighth mile with a ZZ-4 crate engine, 625 street demon carb, pump gas, glide, 4.86 gear 33x10.5w tire, 1250 lbs. I've been a lot faster but it sure cost more and was a lot harder work. Can't wait to see what the little blower engine will do!

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1138
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: times and combos
« Reply #7 on: February 23, 2013, 11:33:05 AM »
2003 Neil and Park's 215 W.B. 394 cube small block Chevy, Glide 4.56 gear 33x12 tires 2 Ron's terminator's Alcohol injected . Once and awile we spray it with 200 hp Nitrous . Run's 7.40's at 181 on motor and our best ET on nitrous 6.94 at 192.

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1138
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: times and combos
« Reply #8 on: February 23, 2013, 11:36:19 AM »
406 sbc, 2-3/4 hilborn
Powerglide, 1.69 1st gear
Coan 7500 stall converter
4.30 rear gear
31x12 goodyear
7.63@173
  and want to go faster
How is that 1.69 low gear working for you ? I would like to try one myself  Bill Masiello

Offline Quartermiler

  • Newbie
  • *
  • Posts: 21
    • View Profile
  • Your Best Time: 7.61 in the quarter 174.2 mph
  • Your Engine: 406 SBC on Alcohol
  • Your Track: Mostly Northern TX southern OK
  • Your Vehicle: 1965 Jim Davis Chassis
Re: times and combos
« Reply #9 on: February 23, 2013, 01:26:27 PM »
Run the same set up as cajuninjector but a 1:80 low gear in the powerglide best e.t. 7.67 best mph 171.9 at Tulsa this past Sept at the Nitro Nationals.

Offline buickfed

  • Full Member
  • ***
  • Posts: 191
    • View Profile
Re: times and combos
« Reply #10 on: February 23, 2013, 04:28:00 PM »
our first time, last may, we broke the dedenbear glide. too hot of summer so our next time out was sept. we were running a buick 4.1 v6. this is the 5th or 6th car this engine been in. we did a best of 11.77 @ 111. not bad for a tired engine. the buick 350 going in next should take into the low 9's to start.

Offline Cajuninjector

  • Jr. Member
  • **
  • Posts: 64
    • View Profile
  • Your Best Time: 7.50@176
  • Your Engine: SBC 406 Alky Stacked Hilborn
  • Your Track: SWJFA
  • Your Vehicle: 225" FED-Wizard Race Cars
Re: times and combos
« Reply #11 on: February 23, 2013, 05:21:39 PM »
406 sbc, 2-3/4 hilborn
Powerglide, 1.69 1st gear
Coan 7500 stall converter
4.30 rear gear
31x12 goodyear
7.63@173
  and want to go faster
How is that 1.69 low gear working for you ? I would like to try one myself  Bill Masiello
We like it. Had the 1.80 and it was too hard of a hit off the start. It's also what Scott and Frank suggest. I take their advice no matter what I think because I don't know xxxx. Lol
Go Hard or Go Home

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1138
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: times and combos
« Reply #12 on: February 24, 2013, 08:09:41 AM »
406 sbc, 2-3/4 hilborn
Powerglide, 1.69 1st gear
Coan 7500 stall converter
4.30 rear gear
31x12 goodyear
7.63@173
  and want to go faster
How is that 1.69 low gear working for you ? I would like to try one myself  Bill Masiello
We like it. Had the 1.80 and it was too hard of a hit off the start. It's also what Scott and Frank suggest. I take their advice no matter what I think because I don't know xxxx. Lol
Frank know's his stuff and just a fun guy to talk to!

Offline George

  • Hero Member
  • *****
  • Posts: 518
    • View Profile
  • Your Vehicle: 1964 Mercury Comet Super Stock/ M automatic
  • General Location: Midwest USA
Re: times and combos
« Reply #13 on: February 24, 2013, 10:10:54 AM »
Our 355 runs low 5.s in 1/8 at 137 mph. At our home track in Havana Illinois.

4.030 bore 3.48 stroke.

Hilborn 2 7/16"

Alky

1.8 PG . Stalls about 6200

4.30 Mopar 8 3/4

Goodyear 12 X31

GREAT site! Thanks.

U-Tube video of our car at Havana: http://www.youtube.com/watch?feature=player_detailpage&v=_w7jl8Fbmyg
« Last Edit: March 24, 2013, 04:19:43 PM by George »

Offline AF150

  • Jr. Member
  • **
  • Posts: 92
  • The Devil is in the Details
    • View Profile
  • Your Best Time: 7.37 1/4 mile
  • Your Engine: Early Hemi, 365", Blown Alky
  • Your Track: Tulsa Raceway Park
  • Your Vehicle: 200" FED
Re: times and combos
« Reply #14 on: February 25, 2013, 12:10:48 PM »
We run the following combo...
200" home-built FED, Motor out 44", Powerglide w/ 1.69 low, Wilson converter 5000 stall,
1956 Chrysler 354, .060 over (365 cu.in.), All Iron, Stock crank (except for turning rod journals
down to big block Chevy size), MGP Al. rods, 11.5:1 Arias pistons, Bowers 6-71 blower running
10% Under, Enderlie bugcatcher on straight alcohol, MSD mag @ 30* ign. timing, 14x31-15
Goodyears, 4.10 gear.
Best results so far...
1.09 60 foot, 7.37 /180 quarter...4.63 /151 eighth mile.
This deal has been pretty low maintenance and reliable
« Last Edit: February 25, 2013, 12:13:51 PM by AF150 »
MB