Author Topic: front axle concern  (Read 5170 times)

Offline bad penny

  • Newbie
  • *
  • Posts: 16
    • View Profile
  • Your Engine: bbc alcohol 540
  • Your Track: castrol edmonton
  • Your Vehicle: 2008 185 tuttle
front axle concern
« on: July 01, 2014, 08:22:31 AM »
Bought this car as a roller.it did tag the wall and front section was replaced.Repair was done nice.looking at axle and noticed that the uprights the chrome has cracked/fractured.Im leaning on replacing the axle assembly.Is this the way to go or am I going overkill?

dreracecar

  • Guest
Re: front axle concern
« Reply #1 on: July 01, 2014, 10:52:02 AM »
Have the chrome stripped and then inspect the axle

Offline rooman

  • Moderator
  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: front axle concern
« Reply #2 on: July 01, 2014, 01:33:11 PM »
What Bruce said.    :)

Roo
Yeah, I am from the south--any further south and I would have been a bloody penguin.

Offline ricardo1967

  • Hero Member
  • *****
  • Posts: 578
    • View Profile
  • Your Best Time: No full pass yet.
  • Your Engine: Alky SBC 400
  • Your Track: Brown County Dragway (Bean Blossom, IN)
  • Your Vehicle: 173" FED
Re: front axle concern
« Reply #3 on: July 01, 2014, 02:14:11 PM »
Have the chrome stripped and then inspect the axle

Hey Roo, is this a service you can do for a fee?

I share the same concern. My car (173" FED) has a SPE front axle, but it does look a little sagged. It has signs in the middle point showing it has flexed enough to touch the asphalt a few times. It's a rigid front assembly, which further taxes the front axle. I just love the nostalgic look of the SPE front axle!

PS.: Bruce, nothing against you, but I'm one hour from Roo.

Offline bad penny

  • Newbie
  • *
  • Posts: 16
    • View Profile
  • Your Engine: bbc alcohol 540
  • Your Track: castrol edmonton
  • Your Vehicle: 2008 185 tuttle
Re: front axle concern
« Reply #4 on: July 01, 2014, 03:04:16 PM »
Will strip and inspect.If I have a bracket issue can I replace or will it take the strenght out of it?