Author Topic: front wing on a fed.  (Read 6475 times)

Offline ricci32

  • Full Member
  • ***
  • Posts: 142
    • View Profile
  • Your Engine: sbc ,gas, 358cid
  • Your Track: Lebanon Valley
  • Your Vehicle: Vintage style FED
front wing on a fed.
« on: June 24, 2014, 05:49:54 AM »
I just built a front wing for my fed. its 16 wide by 10.5 deep what is the ideal placement on the front of the car. looking at other cars some are mounted high others are low close to front axle and chassis. also what is a good angle.
 

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2058
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: front wing on a fed.
« Reply #1 on: June 24, 2014, 06:09:52 AM »
I just built a front wing for my fed. its 16 wide by 10.5 deep what is the ideal placement on the front of the car. looking at other cars some are mounted high others are low close to front axle and chassis. also what is a good angle.
 

Take a look at this thread

http://www.frontenginedragsters.org/forum/index.php?topic=511.0
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1910
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: front wing on a fed.
« Reply #2 on: June 24, 2014, 06:52:31 AM »
angle would be hard to say,well for me anyway. Speed,where its located(clean or dirty air) ,wing design and how much downforce is needed.All have big effect.  I would start low maybe 2 to 4 degrees and move up a degree at a time and see how it effects handling,et and mph. Remember more angle more drag don't go so far that your slowing car down with ton of drag. On well designed wing theres a break point where drag goes up miltiple to downforce achieved.On my wing on the TA/D after 8* drag went up big time but downforce increase was about a 1/4 of drag increase. It also had down force at negative 2*.

 We where running  Alcohol Funny at  Darlington and car was moving on top end.Added 3/4" lip at 15*  to deack and car went straight as arrow and actually picked up cpl mph. It don't take alot at times.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

dreracecar

  • Guest
Re: front wing on a fed.
« Reply #3 on: June 24, 2014, 09:05:09 AM »
How do you know if you really need a wing?? Lots of fast cars out there running without one. But they do look cool. Close to 18 years of running one on my car and I never once checked what the angle was/is. There is no formula out there for what is best for any particular car. You need to get the car out on the track to see what it does and make adjustments to that.

Offline ricci32

  • Full Member
  • ***
  • Posts: 142
    • View Profile
  • Your Engine: sbc ,gas, 358cid
  • Your Track: Lebanon Valley
  • Your Vehicle: Vintage style FED
Re: front wing on a fed.
« Reply #4 on: June 24, 2014, 09:56:45 AM »
A big part is the cool factor would also like to place it correctly.

dreracecar

  • Guest
Re: front wing on a fed.
« Reply #5 on: June 24, 2014, 02:00:06 PM »
Whatever is right to the eye and start from there

Offline slingshot383

  • Full Member
  • ***
  • Posts: 146
    • View Profile
  • Your Best Time: 1/4 mi. 7.95 @ 168
  • Your Engine: Chrysler, alcohol, 528 cu.in.
  • Your Track: Gateway Motorsports Park (the Swamp)
  • Your Vehicle: Undercover Chassis 23T altered
Re: front wing on a fed.
« Reply #6 on: June 26, 2014, 03:43:25 AM »
A cool way to mount it (if you have a torsion bar, is to have it be an active wing that increases angle of attack as the front end rises.  This was done on some of the old cars, and it helped balance the front end at speed.
Undercover 23T Altered, big block Mopar
Member of the Torque and Recoil Club

dreracecar

  • Guest
Re: front wing on a fed.
« Reply #7 on: June 26, 2014, 07:18:44 AM »
To which if you have to follow the rules is not legal, all wings must be fixed