91
Spud Miller's Cave / Re: Not seeing any gains !
« on: October 29, 2019, 12:58:31 PM »More timing with more Nitro ?I know nothing but I think at 25% you treat it as an alky engine still.
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
92
Drag Racing / Re: Old worn out blower vs brand new stripped Littlefield
« on: October 14, 2019, 03:19:52 PM »
Yes at least 800
93
Drag Racing / Re: Old worn out blower vs brand new stripped Littlefield
« on: October 14, 2019, 10:07:56 AM »
I would hold it out to 1000
94
Your Builds / Photo Gallery / Re: New A/F car on the fixture
« on: October 11, 2019, 09:28:27 AM »
Oh yes very cool
95
Your Builds / Photo Gallery / Re: New A/F car on the fixture
« on: October 10, 2019, 06:38:01 PM »
Looks great as usual Bruce that throttle pedal is so cool!
96
Rear Engine Dragsters / Re: First Win
« on: September 25, 2019, 08:41:59 PM »
Congratulations on the first win!
97
Wanted to buy / Re: WTB safety gear
« on: September 24, 2019, 12:02:57 PM »
Big Ben at DJ safety just posted a deal on -20 suit of FB yesterday may want to call him
98
Altereds / Re: Ran our first seven!
« on: September 18, 2019, 10:34:13 PM »
I had a roll over valve on my car for a while had to leave the fuel cap loose until I was buckled in or it would pressurize my fuel tank. I changed it out when I front halved my car
99
Roo Man's Room / Re: Front Tire Change
« on: September 13, 2019, 08:03:56 PM »
Yes the Goodyear or Hoosiers suck to mount take them to a motorcycle shop
100
Roo Man's Room / Re: Wheelie Bars
« on: September 10, 2019, 03:24:37 PM »
Yes it works but some people watching my car tell me it flexes a ton and may cause problems later.
101
Roo Man's Room / Re: Wheelie Bars
« on: September 09, 2019, 05:53:00 PM »
I am thinking I should change mine its a really long bar 7 long made from 1 .058
102
Roo Man's Room / Re: Wheelie Bars
« on: September 09, 2019, 09:10:17 AM »Generally .058" PM me your e mail address (or cell #) and I will send you some photos. The files are too big to post here.
Roo
Roo, out of curiosity do you build a shorter bar for cars with clutches. I am noticing quite a few of the clutch cars run pretty short bars compared to what I have seen with automatics
104
Front Engine Dragsters / Re: Fed build design ?
« on: September 03, 2019, 08:41:58 PM »
A low 7 second 145-155 WB FED would be a wild little car! I know nothing about what it would take to make a short FED but if I did I would use a wide front axle and a torsion bar just for the fact it would look cool! You could build a 350 blown SBC with a 6-71 bug catcher and a Vertex mag and run however hard you want to run it.
105
Front Engine Dragsters / Re: Fed build design ?
« on: September 03, 2019, 06:19:41 PM »
How fast do you want to go?