FrontEngineDragsters.Org Forum

Drag Racing Discussions => Front Engine Dragsters => Topic started by: buickfed on February 24, 2017, 01:49:00 PM

Title: P-S Enigneering parts needed
Post by: buickfed on February 24, 2017, 01:49:00 PM

just cleaned and painted the dragster for this year. found the king pin spindle bushings are worn. does anybody sell them? 

Title: Re: P-S Enigneering parts needed
Post by: dreracecar on February 24, 2017, 05:07:20 PM

Mark Williams sells a bushing kit just for the P&S spindles

Title: Re: P-S Enigneering parts needed
Post by: buickfed on February 24, 2017, 07:28:34 PM

thanks

Title: Re: P-S Enigneering parts needed
Post by: buickfed on February 25, 2017, 04:45:12 AM

I checked out their site. the parts were for later p-s's. lucky me I have an early version. did send them an email for further info. might have to make my own.

Title: Re: P-S Enigneering parts needed
Post by: dreracecar on February 25, 2017, 08:22:48 AM

P&S only made one version,  what is so different about yours????   Some dragster guys use to cut down the bushings flat to the top of the spindle to run solid flat arms and caps, and the heavier F/C ran the full bushings with holes in the arms. are they stamped P&S??  Rebushed many a P&S (old and new) when TAK (P&S) was around and they were all the same kit/bushings

Title: Re: P-S Enigneering parts needed
Post by: buickfed on February 25, 2017, 09:18:41 AM

the bushings shown have shoulders and the caps are thru holes. mine does not. I guess mine is the cut-down version as you stated.
thanks