FrontEngineDragsters.Org Forum
Technical => Spud Miller's Cave => Topic started by: crider on December 11, 2016, 05:15:06 AM
-
I just picked up a used hilborn stack injection manifold for a bbc. It's a 2 7/16 butterfly model, currently setup for gas. Planning to send it out to be swapped over to methanol. My question is, what size pump will I need for that? Also what other pieces do I need, besides a fuel shutoff? As of now it's just the manifold with nozzles, hoses and barrel valve.
-
6.5 gal, that way you can trim it down and later if you switch to blown you don't have to buy a new pump
-
Thanks Bruce. So that would be an 80a-1 in an enderle, what hilborn pump is that equal to?
-
hilborn 150 is just under 7 gpm
-
Ok, thanks