FrontEngineDragsters.Org Forum

Classifieds (Please No Dealers) => Wanted to buy => Topic started by: hotrod316 on October 06, 2017, 06:25:48 AM

Title: alum small block
Post by: hotrod316 on October 06, 2017, 06:25:48 AM
looking for a good used alum gm  small block (410 motor)
moving on up!
thanks
steve m
Title: Re: alum small block
Post by: alkyal on December 31, 2017, 12:25:55 AM
Did you find a Block? I have a Rodeck that has NOT been Blown Up. It will probably need new Sleeves as its @ .030 over. I will have to check. Has SBC cam bearings. Believe the rear cap is Wet Sump. If interested please reply with a contact number. I am in Ohio. Price will B reasonable as I dont have a real use for it and cant use for our purpose. Thanks Al
Title: Re: alum small block
Post by: hotrod316 on December 31, 2017, 09:08:31 AM
Al, yes we found one but always looking for a back up block  how many nickels?
 
Title: Re: alum small block
Post by: alkyal on December 31, 2017, 10:02:07 PM
Will check some dimensions and post with asking price by Weds  Al
Title: Re: alum small block
Post by: alkyal on January 07, 2018, 02:01:24 PM
What I have is an Older Rodeck. Std size Babbit SBC cam Brgs. The Liners are worn .030. Would clean-up @ .035. The rear cap is a dry Sump. Main Caps-Studs and nuts-washers are there also. The block has some damage from a rod-s failure in #1 ad #2. Was run like this. Asking 750.00 plus shipping from Ohio. Block has Rodeck 350 Plus cast into front. Mains are 400 size.
Title: Re: alum small block
Post by: hotrod316 on January 08, 2018, 05:35:31 AM
thanks will check it out
Title: Re: alum small block
Post by: deepwoods on January 15, 2018, 06:31:27 AM
ALKYAL,
Call 440-749-0182
Title: Re: alum small block
Post by: OldSchoolHP on January 11, 2020, 11:25:56 AM
What I have is an Older Rodeck. Std size Babbit SBC cam Brgs. The Liners are worn .030. Would clean-up @ .035. The rear cap is a dry Sump. Main Caps-Studs and nuts-washers are there also. The block has some damage from a rod-s failure in #1 ad #2. Was run like this. Asking 750.00 plus shipping from Ohio. Block has Rodeck 350 Plus cast into front. Mains are 400 size.

Did you sell this block?