Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - spookie

Pages: 1 2 [3]
31
Dan Dishon's Transmission Den / trans goes backward in low
« on: April 25, 2015, 04:31:24 AM »
Update on PG woes.New band fell apart!! Top brand name band,but it looks like friction never bonded to band.Messed up drum,and a clean up of trans will fix.A one in a million event.

32
Dan Dishon's Transmission Den / power glide goes backward in low
« on: April 14, 2015, 05:08:03 PM »
took my just rebuilt pg out,first run seemed fine. 2ed time run,did burn out in high,backed up,all seemed well.put it in low to stage,it went backward!! trans linkage checked out.High and reverse are OK.trans brake not holding. Is this a band not working,checking adjustment later this week,what else should I check?

33
Front Engine Dragsters / front tire air pressure
« on: March 31, 2015, 01:20:53 PM »
How much air pressure for 17"x2.5 front tires.Running 35psi, is that to much? 400 lbs on front end.

34
Front Engine Dragsters / 9 inch center section?
« on: January 02, 2015, 02:50:37 PM »
Installing new Strange aluminum center section.What is the best way to seal it to housing? How tight should nuts be to housing? Thanks for any help. Happy new year,lets RACE. :P

35
Dan Dishon's Transmission Den / trans temp
« on: October 11, 2014, 08:16:09 AM »
F.E.D. with PG trans,spragless converter.5200 rpm stall. Reaction times move around based on trans temp.Is this normal? 180* seems tobe best temp. Trans is covered so it is hard to cool.Any insight would be helpful. P.S. redline  "f' fluid

36
Front Engine Dragsters / locked timing
« on: September 13, 2014, 04:59:06 AM »
sbc on alcohol, msd dist, locked timing at 30* now have starter kickback. I spin motor then turn on iginion,still have kickback. Should I undue locked timing. P.S. using injection.

37
Wanted to buy / Kinsler nozzles
« on: August 31, 2014, 04:16:55 AM »
looking for kinsler nozzles 1/8 npt 90* 7/16 body ,A style deflectors 4 RH 4 LH  .028 size

38
Spud Miller's Cave / nozzle size
« on: July 27, 2014, 07:45:48 AM »
just changed heads.Went from .066 pill to .o54 .Do I need to change nozzles? Have #0 pump with Kinsler  code m410 nozzles.{.026 ?} Picked up 1/10 in 1/4mi Seems to run fine,worring about to high of pump pressure. Thanks for help.

39
Front Engine Dragsters / fuel cell size
« on: April 26, 2014, 04:46:55 AM »
what size fuel cell for 1/4 mile. I drive to staging lanes and back.This is a small block 406 with stack injection on alcohol.

Pages: 1 2 [3]