Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - spitzerscott

Pages: 1 ... 6 7 [8]
106
Front Engine Dragsters / Re: FED photos
« on: February 07, 2014, 09:18:29 AM »
proriv63,  The old silver bodied car ran 6.20's in the eighth mile.  Purple bodied car ran 8.90-9.00 in the quarter.

107
Front Engine Dragsters / Re: FED photos
« on: February 06, 2014, 02:09:48 PM »
Thanks for your help Glenn, they look good.

108
Front Engine Dragsters / Re: Received anr e-mail from a member beegodwin
« on: February 05, 2014, 10:36:59 AM »
Welcome, good lookin' ride.

109
Front Engine Dragsters / FED photos
« on: February 05, 2014, 08:43:15 AM »
Since I'm home snowed in here in Kendallville, Indiana I will dig around later and find pics of my past dragsters and see if I can fiqure out how to scan and post.

110
Spud Miller's Cave / Re: On board primer
« on: February 02, 2014, 06:09:33 PM »
Yes, I used the Enderle  check.  I think they are set at 4psi.

111
Spud Miller's Cave / Re: On board primer
« on: February 01, 2014, 03:37:19 PM »
BK, I thought about the fuel in the lines,  I didn't know how much alcohol would eat on the pump.  I'm going to give it a shot, I guess we'll know come spring.

112
Spud Miller's Cave / Re: On board primer
« on: February 01, 2014, 12:45:11 PM »
Bill, my pump looks just like that, solid state Purolator.   Any special reason you went into the intake instead of the dist. block?

113
Spud Miller's Cave / On board primer
« on: February 01, 2014, 10:30:12 AM »
Just added an on board primer system.  Small tank plumbed to an electric fuel pump with the line plumbed into the distribution block. We run alcohol, I was thinking of priming with gas to keep from washing down a cylinder, does this sound ok?  How do you guys do it?  I was thinking maybe a 3 count or 5 count then hit the starter. Or should they be operated at the same time?  336SBC, single butterfly, N/A.   Any Advice?

114
Rear Engine Dragsters / Re: Newbie Intro
« on: January 26, 2014, 01:24:48 PM »
Glenn, I will keep everybody updated.  We have to start with the license passes and all.  I sure hope he doesn't want me to make the shakedown passes, I have never driven a RED, but I can recall how to drive a FED. I will make a few passes before it's all said and done.

115
Rear Engine Dragsters / Newbie Intro
« on: January 26, 2014, 10:37:09 AM »
Hi guys, I currently have a Spitzer RED 225 hardtail that my son will run in Super Pro.  We have a 336 smallblock  Chevy, N/A single butterfly mechanical fuel injection, 100% alcohol.  13.2cr, 600 lift, alum. heads. Powerglide 1.82 low, Aluminum MW modular rear with 4.10 gear. This will be my sons first dragster. I ran front engine cars in the mid 70's and 80's.    Current RED has a Spud Miller flowed pump and is set up on Spud's advice. Looking forward to first full pass.

Pages: 1 ... 6 7 [8]