Topics

1

Wanted to sell / 427 SBC Alcohol Injected

« on: February 07, 2016, 09:56:03 AM »

Injected Alcohol 427 cubic inch SBC built by Tom Martino at MB racing engines in Farmingdale NJ
12 runs on engine
14.2-1 compression ratio
Dart SHP block
Eagle Forged Crank
Eagle Max Stroker Rods
Wiseco pistons
Brodix sts t1 227 CNC ported heads
Comp Cams roller rockers
Crane stud girdles
Lunati pushrods and lifters
Mech roller cam, with cam card
MSD Pro-billet distributor
MSD flying magnet crank trigger
ATI super damper
Injected on Alcohol
Enderle Bug Catcher on an Edelbrock tunnel ram.
Enderle 80A-5 fuel pump 15 runs
Cloyes Double Roller chain with Billet gears
Moroso 7 qt oil pan
Melling Select oil pump
Zoomie Headers not included

Have a log book with tune-up information, all runs on this motor are documented.
This engine was in a Front Engine Dragster and has run 7.92 at 165mph, in a 1600lbs car.
$8250.00  located in Bradenton FL,
Call Jeff Morris at 941-321-6069 or novadude66@gmail.com

2

Front Engine Dragsters / Wilwood rear disc brakes

« on: November 12, 2014, 07:13:09 PM »

I'm having a hard time keeping my Wilwood discs on my FED released, has a 2lb residual valve and dynalite calipers. Does anyone have any suggestions?? Pulling my hair out!!!