301
Front Engine Dragsters / Re: bracket racing a FED ...
« on: March 09, 2013, 05:05:43 AM »the majority of todays bracket dragsters are RED's , lets hear what it would take for a FED to run in todays highly competative electronics class .
if you where to build a fed for just bracket racing , how would you set it up ?
motor size / power ?
tire size ?
rear gear ?
lentgh of car ?
engine placement ?
im going to build a FED here in the next few months and hoarding parts . here is what im thinking so far
200" car
383 sbc injected alky , make around 650hp
2 spd glide with 1.80 gear
rear gear im thinking around the 4.33 range
rear tire not really sure , im thinking a 29x12 slick should do well ?
any advice ? we dont see many feds in the bracket classes these days and my local track has an easy 40+ dragsters in super on any given sunday , so id like to be some what competative ...
thanks !
Been there done that. It's a blast. On your combo, if I could pick anything I wanted I would use a full length glide 1.76 ratio, 4.10 gear, 32x14 tire. With an injected 355 and a short glide 175in car I had to slow it down on the starting line a little to get it to repeat. It would hit the wheelie bar to hard and unload the tires. Be prepared after a few rounds on 90 degree day cockpit will be HOT.