Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - beargeorge

Pages: [1]
1
Rear Engine Dragsters / Rear engine dragster chassis update
« on: May 25, 2017, 07:16:00 AM »
I have an older S&W re dragster with currant 7.50 tag, what would it take update the chassis to run a 7.00 class,also is a chrome roll bar acceptable.

2
Roo Man's Room / Altered chassis question
« on: May 19, 2016, 12:10:57 PM »
I am building an altered useing both  the Mark Wiliams blueprint and the SFI chassis specs10.2  for6.00 =7.49seconds e.t..My question is the rear uprights that connects the bottom rail to the shoulder hoop the one that connects the rearend to the chassis.SFI calls for inch and a quarterx0..58 M.W.AA calls for inch and 3 eights x 095,which one do you guys prefer.

3
Roo Man's Room / Chassis print
« on: April 26, 2016, 07:48:37 AM »
Could someone tell me if the Mark Williams chassis blue print for a funny car chassis is up to date,print #15101 if it is up to date what will it cert for. Thank You.

4
Wanted to buy / Funny Car Seat
« on: March 30, 2016, 01:24:09 PM »
Looking for a funny car seat aluminum,fiberglass or carbonfiber.

5
Altereds / Altered seat
« on: March 30, 2016, 09:00:31 AM »
I am in need of a fiberglass seat for an altered on an newer funnycar chassis,shoulder hoop is 21 inches wide. Thanks

6
Front Engine Dragsters / Mark Williams front engine dragster print
« on: November 17, 2015, 05:01:05 PM »
I am in need of a MW fe dragster working print copy ok,mine got water damaged , let me know what you have and price

7
Roo Man's Room / Engine location
« on: September 17, 2015, 05:32:13 PM »
Front engine dragster, 180 inch w.b. BB Chev.powerglide long or short? M.W. modular rear,my question is how far out should the motorplate be from the rearend centerline. This is a new build

8
Roo Man's Room / Logghe Chassis Prints
« on: March 14, 2015, 08:27:20 AM »
I am looking to buy a chassis print of the Logghe A&Bsped shop fueler,any help locating a copy would be appreciated.          Bob George        1 774 991 0411

9
Front Engine Dragsters / Parachute Maintenance
« on: September 19, 2014, 10:42:01 AM »
 recently i purchased two used Stroud chutes,they are in good shape but could use a good cleaning, what is the best method to use. thanks, Bob George

10
Roo Man's Room / Shorty body question
« on: August 14, 2014, 06:07:36 AM »
Is 040 3003 mill finish okay for a fed shorty body

Pages: [1]