1411
Spud Miller's Cave / Re: Enderle barrel valve adjustment question
« on: August 07, 2014, 10:57:30 AM »
Not sure richening is correct way to go.Normally a slight lean would have lots of response. Will to rich might have stumble. 28% is very close in the ball park. Is sytem just rich?
Heck try 2 maybe 3 flats thats pretty big move IMO if does not work go back then 2 flats over direction.Remember theres plenty of fuel sitting there when you open barrle to full flow engine has to pull air in to mix with it .Its not like a crapurator where the incoming air pulls fuel.
Without knowing full system its hard to say how to tune it with a edumacated guess.Pump size nozzle size and main jet all play into it.
Heck try 2 maybe 3 flats thats pretty big move IMO if does not work go back then 2 flats over direction.Remember theres plenty of fuel sitting there when you open barrle to full flow engine has to pull air in to mix with it .Its not like a crapurator where the incoming air pulls fuel.
Without knowing full system its hard to say how to tune it with a edumacated guess.Pump size nozzle size and main jet all play into it.