FrontEngineDragsters.Org Forum

Drag Racing Discussions => Altereds => Topic started by: draper on April 13, 2015, 07:24:54 AM

Title: G,day from Australia
Post by: draper on April 13, 2015, 07:24:54 AM

My name is Glen and I am from melbourne Australia, here are a few pic's of my unfinshed ride. It's a 105 inch moly tube Topolino altered powered by a blown / injected 392 hemi, powerglide, floater 9 inch rear. Started project with a rolling 125 inch mark Williams chassis ( was injected small block 9 sec car ). All mods / fabrication done by myself in home shed, project is about 12 months away from testing - should be mid 7 sec ride if all goes well, hope you like. Glen

Title: Re: G,day from Australia
Post by: JeffV8 on April 13, 2015, 07:42:41 AM

Looking good

Title: Re: G,day from Australia
Post by: H.G. Wells on April 13, 2015, 08:23:34 AM

Welcome Glen.
good looking hot rod there.

Title: Re: G,day from Australia
Post by: dreracecar on April 13, 2015, 08:32:46 AM

Chassie tune advice----Equal pressure in rear tires, jack up the front at the torsion and make sure the left front spindle is at least 1/4" lower than the right.

Title: Re: G,day from Australia
Post by: arush on April 13, 2015, 04:52:49 PM

Very Nice Piece.

Title: Re: G,day from Australia
Post by: ricardo1967 on April 13, 2015, 05:17:49 PM

It looks wild & handful: the altered epitome!

Congrats and welcome.

Title: Re: G,day from Australia
Post by: Draw 3D on April 13, 2015, 08:35:22 PM

Welcome Glen and really liking your hot rod  ;)

Title: Re: G,day from Australia
Post by: retroboy on April 29, 2015, 05:35:50 PM

Nice car Mate!  Hopeing to get a few laps in at Mildura next year - see you there ?