46
Front Engine Dragsters / Re: Howdy!
« on: February 08, 2013, 04:36:08 AM »
what gear do you have in the rear?
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
47
Front Engine Dragsters / Re: What did you do on your Front Engine Dragster TODAY?
« on: February 06, 2013, 08:04:33 PM »
All kinds of little machining.
Made spud ends for my tie rod, or thread adapters/whatever. Had to machine a little spacer ring because the hub I got from good vibes has a 2" O.D. while this blower pulley I got off ebay has a 2.250" I.D.
Also, the QC on my enderle timing cover was a little sketchy. Had to enlarge the spot faces for the bolts and deburr the rear of the holes.
Pushrods come tomorrow. Dropping off my cylinder heads in the morning to get the valve seats/valve angles checked. Hope to have the entire longblock wrapped up this weekend.
Made spud ends for my tie rod, or thread adapters/whatever. Had to machine a little spacer ring because the hub I got from good vibes has a 2" O.D. while this blower pulley I got off ebay has a 2.250" I.D.
Also, the QC on my enderle timing cover was a little sketchy. Had to enlarge the spot faces for the bolts and deburr the rear of the holes.
Pushrods come tomorrow. Dropping off my cylinder heads in the morning to get the valve seats/valve angles checked. Hope to have the entire longblock wrapped up this weekend.