59
« on: October 28, 2015, 07:54:06 PM »
Ok now that I have the fed at home, I have a few questions.
with a 2.6a- 7.50 spec, is 2 bolts per side for the rear mount ok? It has the anti rotation bar.
The gentleman who had it before me moved the mid plate out 6 inches so he could fit better (6 ft.+).
I have no problem with it out but the engine sits 2 to 21/2 inches too low.
I need to put a containment pan under the engine so I'd like to raise it up.
1- Put it back the 6 " and see if it comes up? I'll have to move the pedals if I do. it fits good now.
2- Just raise the engine and trans by redrilling/buy a new midplate?
Ideas?
Here is a few pics
Any guess who built it?
The previous owner didn't know.
Thanks in advance
Barry.