Messages

1

Wanted to sell / A/ND or Jr Fuel motor SBC, Powerglide Transmission, Bead lock wheels.

« on: March 23, 2022, 08:01:55 PM »

Cleaning out my garage and realizing I'm never going use this stuff again.

Neil and Parks short block 383 inches (I bought this used from Frank and Scott as a spare and never used it)
4.167 bore x 3.510 stroke
Lightened bowtie block
55mm cam .904 lifters
MGP rods, Honda journal
BME piston blanks machined by Scott Parks
Titanium wrist pins
Comp Cams belt drive with fuel pump mount
Aluminum oil pan
5 Stage dry sump pump and drive mandrel complete
Needs rings and bearings/ freshen up
Have two spare piston blanks, spare lifters and bearings
$6500

New RHS 14 Degree iron heads CNC ported by HVH
New Manley Titanium valves
New ARP head studs special for these heads
$3000

Powerglide transmission right out of my B/ND car as last ran
Reid case with roller bearings/ long tail shaft with roller bearing
Low drag and lightweight everything inside/ some titanium
1.68 low gear
Aluminum valve body
Dip stick/ overflow tank complete
Case needs recertification and a freshen up while your in there
$2500

A1 converter to match engine
$600

Package deal for everything and I'll throw in the flex plate, a brand new set of headers and whatever else I can find for the motor/trans.
$10,000


I also have a set of bead lock wheels
15x12
5x5 bolt pattern
roughly 4.5 back spacing
Aerolite rims that I had Champion add the locks
$1200
Centers are flat plate material so if you are crafty you could make new centers with another bolt pattern

Send me a message or email if interested

 robertdlander@yahoo.com

Thanks
Bob

2

Wanted to sell / Used Racepak V300SD with magneto pick up and 8 EGT's Excellent Condition

« on: January 14, 2018, 07:10:33 PM »

Racepak datalogger out of my dragster, comes with Fuel pressure, Oil pressure, Pan vacuum, MSD promag connector, driveshaft RPM and 8 exhaust gas probes & weld bungs. Complete wiring harness with all modules, software, license disk and instruction books. Serial and USB adapters. Very clean, no oily or burnt cables. No laptop included.
$2500  free shipping. That is half of new.

email if interested

robertdlander@yahoo.com

Thanks
Bob Lander

3

Wanted to sell / Jr Fuel B/ND for sale

« on: April 05, 2015, 10:04:44 AM »

This is a west coast heritage series car. Built on 2006 only has 80 runs total. 215" super lightweight car 1365 lbs with driver. Built for small to medium driver (I'm 5' 8" 165). lots of titanium, carbon brakes,Racepak,fire system. 385" motor cnc lightened cast iron block, raised runner heads, Kinsler Monster injection. This car has the best of everything. Will run 6.90's to 7.0's all day. Will separate.
Email me for pics or go to autoimagery.com and type Bob Lander in search box.

$45,000 turn key, make offer all or part.

Bob Lander
robertdlander@yahoo.com
707-486-9875