FrontEngineDragsters.Org Forum

Technical => Dan Dishon's Transmission Den => Topic started by: wideopen231 on June 14, 2016, 07:23:47 PM

Title: converter to crank alignment
Post by: wideopen231 on June 14, 2016, 07:23:47 PM

Long story short. I machined a adapter midplate for lil brothers new project.A VW vr-6 turbo eninge to powerglide transmission.Lots of hours and cpl bags of chips.
Seems  I have trans about .015 high. going to make inserts  and drill to hopefully get dead on.

I know .0000 would be ideal,but in real world? How much tolerance is there in alignment?

Title: Re: converter to crank alignment
Post by: jeff/21 on June 15, 2016, 04:15:57 PM

why not use offset dowel pins?

Title: Re: converter to crank alignment
Post by: bikeguy307 on June 19, 2016, 04:00:16 PM

I dont know but I think I would do what ever it took to be .000.