FrontEngineDragsters.Org Forum

Drag Racing Discussions => Rear Engine Dragsters => Topic started by: sandhopper2 on December 28, 2018, 09:24:29 AM

Title: Replace the cage
Post by: sandhopper2 on December 28, 2018, 09:24:29 AM

Not sure if I can get some more room by replacing the cage , but any Idea how much it would cost ? It maybe easier to do the entire thing , but could just the front tube and the side tubes be replaced ? I'm in SOCAL

Title: Re: Replace the cage
Post by: THE FRENCHTOWN FLYER on December 28, 2018, 07:27:41 PM

Every bit of $400 if you're lucky.
And you remove the old cage yourself.

Title: Re: Replace the cage
Post by: Draw 3D on December 29, 2018, 09:17:15 AM

I just had my roll cage redone to raise it a few inches and I supplied the pre-bent tubing from Mark Williams, around $350 funny car style, and had a local chassis guy cut the old cage off and fit and welded the new cage at a specific location and the chassis guy charged me $500 and did it in 2 days.

Title: Re: Replace the cage
Post by: sandhopper2 on January 06, 2019, 07:46:06 AM

where to get some CM in socal ?

Title: Re: Replace the cage
Post by: Paul New on January 06, 2019, 09:26:18 AM

For a cage kit go here
https://neilparks.com/roll-bars.html or call up

Quote from: sandhopper2 on January 06, 2019, 07:46:06 AM

Title: Re: Replace the cage
Post by: dreracecar on January 07, 2019, 04:26:13 PM

Aircraft Spruce in Corona (right off the 91 at Autocenter dr.) open Sat @7am, then bring it to me for bending