Messages

76

Front Engine Dragsters / Re: introduction

« on: March 17, 2013, 01:24:31 PM »

Welcome Don nice to have you here.

77

Front Engine Dragsters / Re: Inline 6 in FED?

« on: March 16, 2013, 06:36:36 AM »

Try Steve Ambrose that runs comp elim he may be able to help

78

Front Engine Dragsters / Re: Anybody here run a Jr. fuel car?

« on: February 17, 2013, 07:17:05 AM »

This is a great thread I quit driving in 99 but I still want to stay up on what works just in case I hit the lotto.

79

Roo Man's Room / Re: Line up bar

« on: February 15, 2013, 05:37:56 PM »

Tim what diameter tube are u using.

80

Roo Man's Room / Line up bar

« on: February 12, 2013, 09:40:58 AM »

Roo funny you brought up the line up bar in your other post what do you use and how fancy does it have to be does it need to be solid or can you use a piece of Dom tube or something similar.

81

Front Engine Dragsters / Re: Feds about done with a 632 chevy.

« on: February 12, 2013, 09:32:22 AM »

clutch or glide

82

Roo Man's Room / Front axles

« on: February 06, 2013, 06:40:10 AM »

Roo I see solid front axles with and without radius rods. Most without are the shorter new style is there a rule of thumb as to when they should be used as far as axle length.

83

Roo Man's Room / Re: slip joint fed

« on: February 02, 2013, 11:10:39 AM »

Wide open do you have any close up pic's of the way your doing your slip joints and are you going to run a glide or a clutch.

84

Front Engine Dragsters / Re: FEDs Forever!

« on: February 02, 2013, 06:59:23 AM »

Thanks for the invite Glenn it will be nice.

85

Front Engine Dragsters / Re: about time there was FED forum

« on: February 02, 2013, 06:54:45 AM »

Wide Open it looks good I'm in the same boat been out since 99 and I want to get back out there.

86

Front Engine Dragsters / Re: New NT/F from Illinois

« on: February 01, 2013, 06:49:07 AM »

Roo what late model block seems to be the most popular for NT/F? I think the fact that most people don't know what combination to to get started with hurts the nostalgia deal. I seen the pic's of this car on the HAMB you did a great job Roo.