FrontEngineDragsters.Org Forum

Technical => Dan Dishon's Transmission Den => Topic started by: H.G. Wells on March 26, 2018, 11:37:13 AM

Title: Longer coupler needed
Post by: H.G. Wells on March 26, 2018, 11:37:13 AM

Finally back to work on my new build, and need a longer coupler due to moving the motor farther out.

Looks like both Mark Williams and Strange have couplers for a max 6" space between the trans rear seal and the face of the rear end coupler.
What are you guys using that will span 7+ inches without going to a long shaft with sleeves like an altered?

Title: Re: Longer coupler needed
Post by: Paul New on March 26, 2018, 12:09:21 PM

Assuming your running a glide? Mark Williams sales the quick disconnect #40876 that requires 6-8” from trans seal to pinion coupler.

Title: Re: Longer coupler needed
Post by: H.G. Wells on March 26, 2018, 01:15:10 PM

Paul you are correct, I did not notice the MW would span that far. Thanks.
They are proud of that one aren't they? The Strange version that goes to 6" is only $175

Title: Re: Longer coupler needed
Post by: Paul New on March 26, 2018, 01:29:17 PM

Yes They are proud of their stuff!