Topics

1

Roo Man's Room / Weld Racing Prostar wheels.

« on: January 19, 2015, 01:26:48 PM »

Hi guys!
I have a set of Weld Racing Prostar front Wheels, spindle mount.  I dont have any wheelbearings, only the mesurements of the bearing seat.
Inner 1.620"
Outer 2.040"
Seal   2.114"
I need to buy the right bearings to be able to build the spindle, I want to have the right mesuraments so I can use other wheels as well.
Does any of you guys no what type of wheels I have?

Best regards.
Palli P

2

Roo Man's Room / Ney guy here.

« on: July 19, 2013, 12:59:32 AM »

Hi there guys.
I have been waching here for a while and reading through your knowledge and it has helped with ideas.  I have tried dragracing With only the rallycross cars I have been competing through the years.  I have also been in formulaoffroad and I have built my rigs self, and had them working my self.  Now I am going to build me a slingshot and try the fun what you guys subscribe on my one 
I have built me a jig, 330 cm long to build the Cage and front of the motor.
I am going to use sbc 350 and th350 auto and a 9" ford.
1.I ordered some blueprints from Mark Williams to see how the proffs build it, are they ok to follow?
2.The drawings show a rail With no suspension front, whats Your appenion on that?
3.I want it shorter, thinkin about 160" is the suspension critical for a shorter car?
4.With that setup, would you have the motor more front and put in a driveshaft?  I am nearly 2 meters long so my legs are allways in the way.
IŽll put in a photo of the jigg, as you can see it is on wheels, Iam planning to work on it home and at my work, so it is easier to move it.
Hoping to learn more from you guys, thanks alot for a good page
With regards
Palli P
Norway.
 

3

Front Engine Dragsters / New guy, from Iceland but living in Norway.

« on: July 18, 2013, 05:49:33 PM »

Hi there guys.
I have been waching here for a while and reading through your knowledge and it has helped with ideas.  I have tried dragracing With only the rallycross cars I have been competing through the years.  I have also been in formulaoffroad and I have built my rigs self, and had them working my self.  Now I am going to build me a slingshot and try the fun what you guys subscribe on my one 
I have built me a jig, 330 cm long to build the Cage and front of the motor.
I am going to use sbc 350 and th350 auto and a 9" ford.
1.I ordered some blueprints from Mark Williams to see how the proffs build it, are they ok to follow?
2.The drawings show a rail With no suspension front, whats Your appenion on that?
3.I want it shorter, thinkin about 160" is the suspension critical for a shorter car?
4.With that setup, would you have the motor more front and put in a driveshaft?  I am nearly 2 meters long so my legs are allways in the way.
IŽll out in a photo of the jigg, as you can see it is on wheels, Iam planning to work on it home and at my work, so it is easier to move it.
Hoping to learn more from you guys, thanks alot for a good page
With regards.
Palli P
Norway.