Messages

181

Spud Miller's Cave / Re: Motor will not fire,keep having to prime 80a pump ? Plugs keep washing out, Help

« on: July 22, 2015, 05:22:41 PM »

my friends fed is had to start the first time after the tank has been emptied the best  way was to jack-up the front higher than the pump after that it starts first shot.

182

Spud Miller's Cave / Re: blown injected gas street sbc

« on: February 28, 2015, 12:26:08 AM »

the guy works on efi everyday and wants to keep it mechanical

183

Spud Miller's Cave / Re: blown injected gas street sbc

« on: February 27, 2015, 08:12:48 PM »

on alky the the only problem  was fueling when on a cruise now i'm working on updating his car changing cam lowering compression, increasing cooling  and now need the fuel system flowed and jetted for a starting platform to start from.and make sure everything is working properly

184

Spud Miller's Cave / blown injected gas street sbc

« on: February 27, 2015, 04:15:52 PM »

My friend has been running a blown injected sbc on methanol on the street now wants to changed to gas. I know this isn't a race car. i had Kinsler set the injection up 20 years ago now i'm looking for someone to check and set it up for gas
sbc 406" 72cc brodex heads, Arias pistons 9.5-1, 6-71 blower Hilbourne hat, if you can or want to do it i'll ship it on monday or refer me to someone thank you

185

Matt Shaff's Engine Shop / Re: Question about custom pistons

« on: December 19, 2014, 04:52:31 PM »

i sprayed the head and cylinder with pam installed the head turned the block up-side down then filled the head and about one to two inches in the cylinder with bondo let it cure then it just fell out leaving a perfect sample. how much nitro you will be running will determine the compression  as stated above flat piston will probably work the best.

186

Spud Miller's Cave / Re: flow ? for spud

« on: September 28, 2014, 06:57:27 PM »

can i ask a question? can the the electric lean-out  be wired to a boost sensor to be activated a a specific value