Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - raceandwin1

Pages: [1]
1
Wanted to buy / Want to buy FED
« on: July 14, 2023, 08:10:57 AM »
I am looking to by a nice 200-225 front engine dragster, not looking for a older car, prefer a Neil & Parks, Fritz and etc..Looking for a super light car...
 Thanks in advance.
email/text
raceandwin1@yahoo.com
817 521-5333

2
Wanted to sell / Re: BRAND NEW ROOMAN FED
« on: February 06, 2016, 12:51:12 PM »
Text me some pics..Or call me  817 521-5333

Thanks,
 Jeff

4
And another

5
Another pic

6
This car has been a race car since the late 70s and has one of the first few sets of Lamb struts produced..Car has been a national event winner ( NHRA) as well as winning Division championships.
The car has a new NHRA chassis certification and is currently being raced right now..
Moser 12 bolt rear, ladder bars, aluminum shocks, Lamb struts, lamb brakes, set up for small block chevy and big block chevy ( have headers for both ). All new Weld V-series wheels and hoosier tires, MSD ignition, K&R pro cube box, throttle stop, elec shift, fuel cell, dual Optima batteries, Ron Davis radiator, two seats, and etc..

Car was just ran at the NHRA National event in Dallas Tx. a few months ago.

Super cool safe car that gets a lot of attention..Car has been in the 8s in the 1/4 with no problems whatsoever.. This car sits right, looks right, and works great!
 It has had a big block in it up until this year ( have plates and headers for both..
  Super cool safe car

Asking $29k LESS ENGINE/TRANS.........Might consider descent front engine dragster and cash

7
I am looking for a front engine dragster and prefer it be the following
 Built in the last few years
Atleast a 21 inch inside shoulder hoop
Around 200 inch wheelbase

If you have a descent car that fits the above please let me know..

Call or text  (817) 521-5333

Thanks in advance

Pages: [1]