FrontEngineDragsters.Org Forum

Technical => Spud Miller's Cave => Topic started by: gregm784 on April 25, 2018, 10:57:18 AM

Title: Prefered port check location & pressure
Post by: gregm784 on April 25, 2018, 10:57:18 AM

In my mind, i see it better that the port check be located at the dist block so the feed line stays full.

Also, my idle check is 5.5#. port check should be............? 10?

Title: Re: Prefered port check location & pressure
Post by: Spud Miller on April 25, 2018, 05:52:45 PM

 Hi Greg!

 Yup, I agree...in the distribution block is the way to go.

 You just want to make sure it's closed at an idle, so typically about 15 PSI is good.

 Spud

Title: Re: Prefered port check location & pressure
Post by: gregm784 on April 25, 2018, 08:14:50 PM

Thanks Spud

Title: Re: Prefered port check location & pressure
Post by: gregm784 on May 05, 2018, 08:44:01 PM

I finalized my port setup today.  idle is 6# (normal for my deal) and the ports pop @ 14#.  We are testing soon. :)  thanks for the .032s.  Adding to my collection. :)  looking forward to having more even plug readings.