FrontEngineDragsters.Org Forum

Classifieds (Please No Dealers) => Wanted to sell => Topic started by: Dragsterboy on August 16, 2017, 02:54:56 PM

Title: 192" Front engine dragster
Post by: Dragsterboy on August 16, 2017, 02:54:56 PM

*1960's Dragster
*Front half of frame is SPE
*Jerry Hill back half and body
*192" wheel base
*331 ci small block Chevy
*Concreted 350 4 bolt block
*Steel big journal 327 crank
*Hilborn alcohol injected
*Brodex aluminium heads
*BME aluminium rods
*2 speed glide with brake
*Olds rear with 4.30 gears
*Runs 9.0's @150mph
*Fits 5-10" 200lbs(ish) driver.
*20 layer fire suit.
*Will need cert & updates to run

There's just WAY to much to list here...

20k cdn
16k usd

Shane
Home 604-853-6900
Cell 778-808-2816

Title: Re: 192" Front engine dragster
Post by: nitroscott on August 17, 2017, 09:10:11 PM

Very Nice. How wide is the shoulder hoop inside and how far is back of motor to center line of rear axles?

Title: Re: 192" Front engine dragster
Post by: Dragsterboy on August 18, 2017, 08:53:20 PM

It's 18" inside to inside of the second hoop to the padding...Probably 19" to the bar.
And it's 33" from the back of the motor plate to the center of the rear axle.
Shane

Title: Re: 192" Front engine dragster
Post by: Dragsterboy on September 07, 2017, 06:20:32 PM

SOLD SOLD SOLD