FrontEngineDragsters.Org Forum
Technical => Spud Miller's Cave => Topic started by: wideopen231 on December 04, 2018, 02:33:38 PM
-
hilborn shotgun injector anyone have one? Need few dimensions. Need to know outside to outside at shaft bearing bores. I have shaft ordered for new project but will take two weeks to get it and want to get head start on building injector and intake. While not a must have its a I want and not holding up anything. Just a project to do at night instead of watching fox news and letting info of stupidity in this world drive blood pressure higher,
I f happen to have shotgun injector and have shaft out for what ever reason. I would love to know distance from outer bearing surface to other.
-
How about center to center on butterflys? easy to figure from there.
-
Howdy wide
I can get you dims off mine. But will be tomorrow most likely
Luke
-
Let me know in case I can't get anyone else.I have question on another site also. Thanks
-
Wide:
So didn't think to ask for accuracy needed. So did a caliper measurment if you need closer I will need more time.
So measuring outside bore to outside bore it showed about 10.815 with the bores being 5.250 + At 5.250 the caliper was a little loose so thus the plus say 2505. Might explain the .815. Sooooooooo this maths 5.565 Cl to Cl. Logic dictates nominal is 5.562 (9/16) ??? Didn't measure land between bores it was cold in a hurry. Would have helped conform the 5 9/16.
Is that a help? My 12 inch wasn't enough to get out side of casting boss's it was shy by like 3/8 's.
Let me know
Luke
-
Great. Lots quicker than Hilborn has been. I can do math as to what divider is. My spilling sucks my math rocks asking any lagging accountant I have ever met.LOL
Gives me exactly what I need to get mill fired up and have ready before shaft arrives.Might even gat adapter box done and be ready to mount.
Thanks a lot.
Chris