FrontEngineDragsters.Org Forum

Classifieds (Please No Dealers) => Wanted to sell => Topic started by: dusterdave173 on January 19, 2015, 12:57:42 PM

Title: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 19, 2015, 12:57:42 PM

Nice Coan 8 inch converter
They advised it is on the tight side for 8 inch so great for big block or blown small block--they said on injected SBC
with decent power 4500-to maybe 5000  killer unit turbo spline for PG  low run time--never opened these are $950 new get this nice converter $450   call 704 244 6649  Thanks

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: George on January 19, 2015, 02:25:59 PM

It's never been opened and low run time ? Is there a part number? Is it built for the midplate? Spragless ?Thanks. George

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 20, 2015, 06:46:19 AM

i will be home this evening and get you the number off it

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 20, 2015, 06:48:23 AM

not built for midplate  Coan makes neat little kits that include a hub spacer and all for different thickness plates and they are cheap--i have used them before they work out great. converter belonged to my neighbor--had it in a car for short while--later quit racing--will tag up this evening thanks

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 20, 2015, 06:44:00 PM

20010210 TJB

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: George on January 21, 2015, 07:08:11 AM

Quote from: dusterdave173 on January 20, 2015, 06:44:00 PM

20010210 TJB

Dave, I contacted Coan this morning. They were quick to respond and excellent advise. It's not close enough for my deal. I am in the 900-1100 hp range. Thanks.

George

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 21, 2015, 01:42:07 PM

Thanks anyway man! It is a good unit for somebody 

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: George on January 21, 2015, 02:12:47 PM

Quote from: dusterdave173 on January 21, 2015, 01:42:07 PM

Thanks anyway man! It is a good unit for somebody

I can forward the build sheet  from 2001 for the convertor if you would like it. George

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 21, 2015, 04:55:55 PM

Cool man  email it to me at  jdk@ctc.net  Thanks !!

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: George on January 23, 2015, 05:30:55 PM

Dave, did you receive the build sheet?

Title: Re: 8 INCH COAN PG/TURBO CONVERTER
Post by: dusterdave173 on January 24, 2015, 06:33:19 PM

Yea man thanks a million!!!!!!!!!!!!!!!!!
I am thinking I may keep it looks like it might work with a SBC and mild blown application--yahoo