FrontEngineDragsters.Org Forum
Technical => Roo Man's Room => Topic started by: gasserx on January 02, 2015, 06:54:58 AM
-
I need to remove the axles to be able to drill some extra holes for the housings chassis mount.
I havent played around with these axles/housings before at all, so i was just wondering if i need a special tool to pull them out before i start, and if i need to replace bearing, gaskets etc before putting it together?
-
Most of the time the rears are set up with Olds bearing ends because of the rather large bearing size so its just the removal of the 4 retainer bolts and a deadblow hammer
-
Thanks dre :)