Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Flakenstein

Pages: [1]
1
Front Engine Dragsters / Re: Can a mild steel FED get certified to 7.50
« on: September 01, 2020, 05:25:40 PM »
Thanks Finnish Fireball, I thought it could but took a lot of razzing when I bought it. Quite a few people from a FED page on FB said I could never get it certified because it was mild steel . I just noticed you race in Finland ? I wonder if the rules are the same in the states ......

2
Front Engine Dragsters / Can a mild steel FED get certified to 7.50
« on: August 31, 2020, 04:16:04 PM »
Hi everybody. I recently purchased a 225`` FED, I bought it for the drivetrain. This car was built with mild steel, tubing sizes and thickness are all correct. They did a nice job on the construction of the car. My question is can this car be certified to run slower than7.50 ? Im just looking to take it out every now and then and have a little fun ....It doesn't have to be extremely fast..... Thanks for your help !

Pages: [1]