FrontEngineDragsters.Org Forum

Drag Racing Discussions => Front Engine Dragsters => Topic started by: PSweeney on November 13, 2016, 09:00:13 AM

Title: Spiral Morse Cables ?
Post by: PSweeney on November 13, 2016, 09:00:13 AM

Where can I get these to length ?

Title: Re: Spiral Morse Cables ?
Post by: rooman on November 14, 2016, 05:27:14 AM

You can order them through Jim and his gang at Good Vibrations (http://www.goodvibesracing.com/) or go direct to the source at Control Cables (http://www.controlcables.com/). Murf McKinny also carries them in even foot (and six inch) increments (http://www.mckinneycorp.com/). Both Good Vibes and McKinney are also used to shipping overseas.

Roo

Title: Re: Spiral Morse Cables ?
Post by: glofria on November 14, 2016, 05:28:07 PM

We've always had good luck withe these folks, but can't say if they will sell to an overseas consumer: http://www.power-trans.net/

Good luck.

Title: Re: Spiral Morse Cables ?
Post by: PSweeney on November 15, 2016, 12:48:41 PM

Quote from: rooman on November 14, 2016, 05:27:14 AM

You can order them through Jim and his gang at Good Vibrations (http://www.goodvibesracing.com/) or go direct to the source at Control Cables (http://www.controlcables.com/). Murf McKinny also carries them in even foot (and six inch) increments (http://www.mckinneycorp.com/). Both Good Vibes and McKinney are also used to shipping overseas.

Roo

Thanks Roo, are these the low resistance, super bendy ones you can virtually tie a knot in ?

Title: Re: Spiral Morse Cables ?
Post by: PSweeney on November 15, 2016, 12:50:18 PM

Quote from: glofria on November 14, 2016, 05:28:07 PM

We've always had good luck withe these folks, but can't say if they will sell to an overseas consumer: http://www.power-trans.net/

Good luck.

Thanks will check them out

Title: Re: Spiral Morse Cables ?
Post by: JrFuel Hayden on November 15, 2016, 01:52:45 PM

Yes, we have used Control Cable with good service

Title: Re: Spiral Morse Cables ?
Post by: rooman on November 16, 2016, 04:38:41 AM

Thanks Roo, are these the low resistance, super bendy ones you can virtually tie a knot in ?
[/quote]

Yep, they still work smoothly with a bend radius of less than 2"

Title: Re: Spiral Morse Cables ?
Post by: PSweeney on November 16, 2016, 06:58:23 AM

great thanks Roo