31
Wanted to sell / Re: Hilborn fuel injection
« on: September 22, 2019, 06:10:37 AM »
Price reduction on this Hilborn SBC injector. Need it gone to take advantage of a sudden opportunity. $1400.00
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
A few years ago there were a few RED's around running Strange's altered struts. More recently there was a builder with a swing arm or link type straight axle front end. The selling point was the ability to keep the front tires on the ground at the launch . The reasoning behind it is that it would help starting line consistency in bracket type rear engine cars that would occasionally and sometimes frequently (depending on xxxx near everything and anything) quickly pop the front tires off the ground and set them back down again almost immediately causing erratic red lights and/or reaction times.
Are you looking to solve an existing problem?
If it worked, they would still be around today and the question would not have to be asked. add the same amount of weight all that stuff weighs to the front and it would keep the front end down too and for much much cheaper
Just so no one gets confused if they happen to find out their rear end uprights aren't .083 wall, the spec Greg quoted is the faster 2.2 spec (5.99 and quicker). The 2.4 spec (6.00-7.49) calls for a minimum .058 upright.
Oops, i meant to include that in my message. thank you.
Yes, that is for 2.4C - Top Fuel.