FrontEngineDragsters.Org Forum
Technical => Roo Man's Room => Topic started by: JeffV8 on September 01, 2015, 01:44:50 PM
-
Should I mount my 331 hemi with solid mounts or use a rubber mount like the speedway set up??
Thanks
-
If you are putting it in a street car a cush mount is the go but for racing (with a tube chassis car) just put a saddle on the top rails that ties to the lugs on the block. The factory mount holes are large so I usually make a "top hat" bush to sleeve them down to 3/8" to match the most common tabs. You can also run front mount plates off the water pump holes, again to saddles and tabs on the top rail.
Roo
-
Thanks Roo, my car has a square tube chassis ,the engine is blown and injected and has a Doug Nash 4+1 tranny. It will more than likely a street car. Some racing.