FrontEngineDragsters.Org Forum

Technical => Matt Shaff's Engine Shop => Topic started by: speedbump on August 05, 2018, 06:45:57 AM

Title: mech.fi
Post by: speedbump on August 05, 2018, 06:45:57 AM
hi matt, maybe you can help me out. I'm running mech. hilborn fi on my nostalgia 1952 mgtd. the fi is on an 327 eng. that was just built for this season. when we went to start it the # 7 cyl. is back firing through the #7 injector tube.  we checked for bad wires, cracked mag. cap, checked valve springs and rocker arms for anything broken or loose also re adjusted the valves.still popping through the #7 inj. tube. this happens mostly at idle. we even checked for vac. leaks.any ideas before we pull manifold and head off. we also did a leak down test and that didn't show us any problems.  we can only try going though all that we checked again. but were hoping for some fresh ideas. Thanks Mike
Title: Re: mech.fi
Post by: jeff/21 on August 05, 2018, 09:07:24 AM
it might be running lean on that cylinder, vaccum leak, or restriction in the line or injector, have found small pieces in the injectors( inside of hose coming apart from age or installition of new fittings) never too clean
good luck
Title: Re: mech.fi
Post by: Frontenginedragsters on August 06, 2018, 07:20:02 PM
speedbump:
 I agree with jeff/21. It sounds like that cylinder is lean
Grab a cheap hand held temp gun and see what the headers have for surface temperature.
Title: Re: mech.fi
Post by: jeff/21 on August 13, 2018, 04:35:16 PM
speedbump, Did you get your problem sorted out?