FrontEngineDragsters.Org Forum

Technical => Dan Dishon's Transmission Den => Topic started by: dusterdave173 on December 04, 2018, 09:07:43 AM

Title: CONVERTER ID HELP
Post by: dusterdave173 on December 04, 2018, 09:07:43 AM
Scored an unknown 8 inch--well built--only stampings are on the center of the nose where it goes into crank it says
B26
2936
3
Just was not sure what company stamped them there --just working to ID this thing
Thanks for the help!!!!!!!!!!!!!!
Title: Re: CONVERTER ID HELP
Post by: THE FRENCHTOWN FLYER on December 04, 2018, 01:58:35 PM
Well,do you know what type of trans it fits? GM? Ford? Three bolt flanges or 4-bolt? What is the pilot diameter size? Spline cpunt?
Title: Re: CONVERTER ID HELP
Post by: THE FRENCHTOWN FLYER on December 04, 2018, 02:00:10 PM
Well,do you know what type of trans it fits? GM? Ford? Three bolt flanges or 4-bolt? What is the pilot diameter size? Spline count?
Title: Re: CONVERTER ID HELP
Post by: dusterdave173 on December 04, 2018, 03:15:08 PM
Yea i know it is 8 in PG spline for Chevy that was not my question
I wanted to know what converter company stamped the numbers on the Hub--that way I can contact them about the inner workings
It is stamped on the center of the hub not on converter body like many--that has to be a "tell" of some certain company
Thanks
Title: Re: CONVERTER ID HELP
Post by: bikeguy307 on December 05, 2018, 07:20:45 PM
Wow what a strange place to stamp a converter, I dont know of any of the major companies that stamp there.