FrontEngineDragsters.Org Forum
Drag Racing Discussions => Front Engine Dragsters => Topic started by: jspell on April 08, 2014, 01:04:48 PM
-
What size headers are you guys using on your SBC race engines? 1-7/8, 2". 2-1/8?
-
I run 2 1/8" just for the look. My heads have the 7 bolt pattern in them . stock can only go to 1 3/4" before you have to run adapters.
-
I just built a set for mine and they are 2 inch . When I ran the collector headers they were stepped 1 7/8 to 2 inch . The zoomies are a little slower
-
we have Stahl adapters and 2in pipes
-
Mine are stepped from 1.3/4 to 2" and have the shape of funny car zoomies.
Stepped are about 2" in length and the pipes are 28-30" long(http://img.tapatalk.com/d/14/04/16/y2yta4u4.jpg)(http://img.tapatalk.com/d/14/04/16/anydezyp.jpg)
You can see where the blue heat mark ends, no idea if that is good or bad. It did not noticably change going from N/A to nitrous.
-
How did your car like the nitrous and how much were you spraying ?
-
Last time out It took an 80 jet on the first kit and 72 on second. Both big shot plates. Second kit came in on the shift.