FrontEngineDragsters.Org Forum

Technical => Spud Miller's Cave => Topic started by: 30dodgeboy on September 18, 2017, 05:27:43 PM

Title: enderle nozzles onto hilborn 4-port
Post by: 30dodgeboy on September 18, 2017, 05:27:43 PM

I have a hilborn 4-port upright injector with the wrong size hilborn nozzles, and a friend of mine has a ton of enderle nozzles. 

What enderle nozzle holders / bodies would work to replace my hilborn nozzles that I have that are too large? 

Would an Enderle 7110 be the right nozzle body to thread into the injector?  Or would that project into the throttle bore too far?

They need the air bleed holes, right?  Can I drill those in myself?

Its a mild 354 with 80A pump on methanol, 4 port with 3" dia butterflies.  No port nozzles (for now).

Title: Re: enderle nozzles onto hilborn 4-port
Post by: gregm784 on September 18, 2017, 09:14:20 PM

Those fit an 1/8" pipe hole.  Should work.

Title: Re: enderle nozzles onto hilborn 4-port
Post by: 30dodgeboy on September 19, 2017, 04:53:51 AM

or would this style be better?

Title: Re: enderle nozzles onto hilborn 4-port
Post by: dreracecar on September 19, 2017, 07:58:33 AM

Match the tip length as close to the Hilborn nozzles a possable. You want air bleeds, it will help in pulling fuel thru the nozzle long with indicating the direction of the fan spray with the AB hole on top. No need for port nozzles, I ran 6.80's @200 with just the hat nozzles and a 375ci.

  Forgot to mention if this was a 4 or 8 nozzle injector

Title: Re: enderle nozzles onto hilborn 4-port
Post by: gregm784 on September 19, 2017, 08:58:00 AM

I'd aim to have them about in the middle of the throttle body if it's a 4 nozzle injector.