FrontEngineDragsters.Org Forum
Drag Racing Discussions => Rear Engine Dragsters => Topic started by: beargeorge on May 25, 2017, 07:16:00 AM
-
I have an older S&W re dragster with currant 7.50 tag, what would it take update the chassis to run a 7.00 class,also is a chrome roll bar acceptable.
-
1 1/2" dia shoulder hoop,
dont know what size cage is on it can be used again or not
-
Chrome plated roll bars have not been allowed to be installed since prior to helmet bars being installed. Does your car have 1" diameter helmet bars?
I think the ruling on chrome roll cages is you cannot do it any more so the older cars with them are OK..... I think
-
The year they came up with that rule, the cover of the rulebook had a roadster with a chrome cage ;D
-
Thank You
-
Yes Paul it has 1inch helmet bars.
-
Yes Paul it has 1inch helmet bars.
Interesting are those bars chrome also? Or did they grind chrome off to weld the helmet bars on?
-
They ground the chrome off,the update was done at S&W ,they also certified the chassis for 7.50,this was done before i bought it.
-
George can you post some pictures?
Also sent you a PM.
-
I will post pictures in a few days
-
Go to my Facebook site for pictures. Bob George