46
Roo Man's Room / Re: Front brakes for SPE spindles
« on: July 11, 2016, 05:00:09 PM »
Thanks Bruce
FEDs Forever!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
47
Roo Man's Room / Front brakes for SPE spindles
« on: July 11, 2016, 08:23:11 AM »
Does anyone make a front brake kit to fit the dragster spindles I know you would have to weld tabs for the caliper mounts this is for an Ohio mile car front brakes are required next year.
48
Front Engine Dragsters / Re: Newrotic Racing Woodburn Dragstrip Oldies but Goodies 2016
« on: June 28, 2016, 06:32:24 PM »
Way to go Paul
49
Front Engine Dragsters / Re: Woodburn Rose Festival Race
« on: June 16, 2016, 11:03:32 AM »
Congrats on the new best Paul you have it flying
50
Matt Shaff's Engine Shop / Re: Balancing
« on: June 11, 2016, 06:01:45 PM »
Thanks for the replies guys I didn't think the heavy pin would hurt as he sprays about 500 on this thing at times with two kits.
51
Matt Shaff's Engine Shop / Re: Balancing
« on: June 05, 2016, 06:14:00 AM »
We got close by going to .250 wall pins now were only around 7 grams lighter than the original piston.
52
Matt Shaff's Engine Shop / Balancing
« on: May 31, 2016, 08:08:29 AM »
Matt we bought a new set of pistons and there 45 grams lighter than what we had do have to rebalance the crank? We weren't expecting them to be different same part number as before.
54
Wanted to sell / Re: 2001 Neal and Parks FED
« on: May 27, 2016, 09:54:35 AM »
Is this car sold no one returns calls on it?
55
Front Engine Dragsters / Re: Started the car last night
« on: May 17, 2016, 09:08:20 AM »
Looks great Paul have fun be safe.
56
Front Engine Dragsters / Re: brake pedal location
« on: January 08, 2016, 09:34:24 AM »
I don't know where your foot will be sitting but in the car I drove my heel was right above the trans brake solenoid and I had to make a shield to cover it because I kept hitting the plunger with my heel not good. I know it don't have to do with the brake pedal just a note.
57
Spud Miller's Cave / Re: Video: Measuring and Comparing Magneto Generators
« on: December 21, 2015, 08:40:06 AM »
Thanks Spud I'll looking forward for more videos.
59
Wanted to sell / Re: 2001 Neal and Parks FED
« on: October 12, 2015, 09:01:58 AM »
What wheel base and cert
60
Wanted to buy / Re: Looking for 10 inch wheels
« on: August 23, 2015, 08:36:14 AM »
I have these M/T 10X15 - 3.5 backspace dual bolt pattern 4.5 and 4.75 mounted never run