Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - beargeorge

Pages: [1] 2
1
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: June 17, 2017, 04:14:19 PM »
Go to my Facebook site for pictures.     Bob George

2
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: June 02, 2017, 05:52:00 PM »
I will post pictures in a few days

3
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 29, 2017, 02:29:10 AM »
They ground the chrome off,the update was done at S&W ,they also certified the chassis for 7.50,this was done before i bought it.

4
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 26, 2017, 10:00:02 AM »
Yes Paul it has 1inch helmet bars.

5
Rear Engine Dragsters / Re: Rear engine dragster chassis update
« on: May 26, 2017, 07:38:34 AM »
Thank You

6
Rear Engine Dragsters / Rear engine dragster chassis update
« on: May 25, 2017, 07:16:00 AM »
I have an older S&W re dragster with currant 7.50 tag, what would it take update the chassis to run a 7.00 class,also is a chrome roll bar acceptable.

7
Altereds / Re: Altered Safety
« on: November 03, 2016, 06:47:09 PM »
Try dragster supply for the driveshaft shield they have one,google for toll free number

8
Roo Man's Room / Re: Altered chassis question
« on: May 20, 2016, 09:51:18 AM »
All set, i was able to get the 1.375x095 cm from Shapiro Steel,i still dont understand SFI calling for 1.250xo58.Thanks everyone for your help.

9
Roo Man's Room / Re: Altered chassis question
« on: May 19, 2016, 03:07:22 PM »
Thank You Paul

10
Roo Man's Room / Re: Altered chassis question
« on: May 19, 2016, 03:03:16 PM »
Thank You, ROO

11
Roo Man's Room / Altered chassis question
« on: May 19, 2016, 12:10:57 PM »
I am building an altered useing both  the Mark Wiliams blueprint and the SFI chassis specs10.2  for6.00 =7.49seconds e.t..My question is the rear uprights that connects the bottom rail to the shoulder hoop the one that connects the rearend to the chassis.SFI calls for inch and a quarterx0..58 M.W.AA calls for inch and 3 eights x 095,which one do you guys prefer.

12
Roo Man's Room / Re: Chassis print
« on: April 27, 2016, 11:52:09 AM »
ThankYou for the advice,ordered the SFI deal.

13
Roo Man's Room / Chassis print
« on: April 26, 2016, 07:48:37 AM »
Could someone tell me if the Mark Williams chassis blue print for a funny car chassis is up to date,print #15101 if it is up to date what will it cert for. Thank You.

14
Altereds / Re: Altered seat
« on: March 30, 2016, 04:27:06 PM »
Thanks Jon i found one.

15
Wanted to buy / Funny Car Seat
« on: March 30, 2016, 01:24:09 PM »
Looking for a funny car seat aluminum,fiberglass or carbonfiber.

Pages: [1] 2