FrontEngineDragsters.Org Forum
Technical => Spud Miller's Cave => Topic started by: BK on May 20, 2017, 04:55:40 AM
-
I just looked at two different schematics for plumbing a high speed lean out with an Enderle Cube and K style barrel valve.
One shows it on the inlet side and the other shows it on the outlet side before the distribution block.
I always thought inlet side was right but that doesn't mean it is.
Is one preferred over the other?
-
At WOT, there's no difference in operation in either spot. I like it ahead of the metering valve so it can help relieve pressure when the throttle is closed at high RPM. Also, on a blown setup, the fewer hoses going past the blower belt the better in my opinion.
Spud