Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Oldschool

Pages: [1] 2 3 ... 9
1
Spud Miller's Cave / Opinions
« on: July 14, 2017, 07:56:56 PM »
😎

2
Getting fuel lines and pump set up. Getting close. 😎

3
Front Engine Dragsters / Re: Oil Filters
« on: June 23, 2017, 04:55:44 PM »
Yes, thinking of getting one. Nice way to check screen for any metal.

4
Wanted to sell / Sold
« on: June 22, 2017, 04:27:56 PM »
Sold local

5
Front Engine Dragsters / Re: Oil Filters
« on: June 22, 2017, 04:20:41 PM »
Little pricey,but very nice.

6
Front Engine Dragsters / Re: Glenn wins procomp at Memphis
« on: June 13, 2017, 08:11:31 PM »
Congratulations !

7
Spud Miller's Cave / Re: Evac
« on: May 31, 2017, 06:39:47 PM »
I run Brad Penn oil and really appreciate everyone's input.

8
Spud Miller's Cave / Evac
« on: May 30, 2017, 05:26:16 PM »
Have a SBC with Enderle injection with bug (Alky). I have a evac system running from my exhaust ( see picture) . My question is will this work good enough for this set up ? I know some recommend a vacuum pump, but the dollars are a little short with getting this set up. One guy told me this would help cut down on milky oil.

9
Front Engine Dragsters / Re: cooling question
« on: May 07, 2017, 03:29:09 PM »
Mine was flat and never had a problem. I did check the water here and there to make sure it was full, but worked great. I am running alky now,so no longer need.

10
Matt Shaff's Engine Shop / Re: Coolant Question
« on: April 30, 2017, 04:06:34 PM »
Aluminum

11
Matt Shaff's Engine Shop / Coolant Question
« on: April 29, 2017, 11:25:59 AM »
I am going to Enderle injection (Alky) and wanting to block off water pump outlets . What would be your recommendation ? I am running a belt drive fuel pump that will bolt up to water pump mounting holes.

Thanks

12
Front Engine Dragsters / Re: Finally Got The Car On The Track
« on: April 28, 2017, 03:55:11 PM »
Nice ride 😎

13
I am changing from carb. set up to Enderle injection. I am basically removing the carb. set -up and just installing the Enderle/ tunnel ram set up. I am installing a primer to have that ability to start engine easy.
Selling my cooling system to. I would not worry about your motor,if built well.

14
Well,started piecing together my Enderle injection system. This is a whole new ballgame for me and should be interesting. I am going to send it out and have it set up.

15
Altereds / Re: New roadster
« on: April 10, 2017, 06:32:56 PM »
Looks like a blast,have fun.  8)

Pages: [1] 2 3 ... 9