Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ducky45356

Pages: [1]
1
Your Builds / Photo Gallery / Re: 175'' build
« on: July 11, 2021, 10:46:21 AM »
Ran the NDRL meet at Norwalk this weekend.First event with the car.Lost first round. but did run a 7.55@183. Really impressed with new build.

2
Spud Miller's Cave / FIE rev limiter
« on: June 07, 2021, 05:35:34 PM »
Having trouble getting FTE rev limiter working. Setup on a super mag. Using the new tach signal pick up. Been over the wiring many times. I get nothing out of rev limiter. When tach is hooked up it doesn't work. When tach is hooked direct to tach signal pickup, tach works. Im at a loss on making this work.

3
Your Builds / Photo Gallery / Re: 175'' build
« on: May 01, 2020, 04:12:06 PM »
so for tribute to my dad and his racing over the years. I had to get the rat from his old car painted on my dragster.

4
Your Builds / Photo Gallery / Re: 175'' build
« on: April 16, 2020, 09:09:44 AM »
I built the tank.  Couldn’t find anything that fit the way I wanted . Cv

5
Your Builds / Photo Gallery / Re: 175'' build
« on: April 14, 2020, 06:15:54 PM »
got chrome done .been slinging paint and a lot of flake.

6
Your Builds / Photo Gallery / Re: 175'' build
« on: March 08, 2020, 03:22:32 PM »
Chassis is finally painted.  rear end is together and in .  working on getting body painted.  all parts are off to chrome and anodizing.

7
Your Builds / Photo Gallery / Re: 175'' build
« on: March 08, 2020, 03:18:58 PM »
Any updates?  Did you make that bell crank?

Yes I made the bell crank.  I have machined all the parts on the car.

8
Roo Man's Room / Re: Building new chassis
« on: April 25, 2018, 04:38:22 PM »
Thank you for the info. Just trying to make sure it certs first time thru. 

9
Roo Man's Room / Building new chassis
« on: April 25, 2018, 04:28:58 AM »
I’m in the process of building a new 2.4c chassis. The sfi book show one single 1.00x.058 bar from cross bar behind rear end going to lower main chassis bar.  This is where seat pan will rest.  My question is can I put in two tubes here or is sfi book all that is allowed

10
Your Builds / Photo Gallery / Re: 175'' build
« on: February 25, 2018, 06:47:05 AM »
more of it finally rolling

11
Your Builds / Photo Gallery / 175'' build
« on: February 25, 2018, 06:45:58 AM »
Started this build in August. Chassis is a Dragster Supply 175'' tacked together kit.  All other fabrication work has been done by me.

12
Roo Man's Room / Re: Steering
« on: February 25, 2018, 06:32:01 AM »
Here are some I made out of aluminum,with nylon bushings in them.

Pages: [1]