FrontEngineDragsters.Org Forum
Drag Racing Discussions => Rear Engine Dragsters => Topic started by: sandhopper2 on December 28, 2018, 09:24:29 AM
-
Not sure if I can get some more room by replacing the cage , but any Idea how much it would cost ? It maybe easier to do the entire thing , but could just the front tube and the side tubes be replaced ? I'm in SOCAL
-
Every bit of $400 if you're lucky.
And you remove the old cage yourself.
-
I just had my roll cage redone to raise it a few inches and I supplied the pre-bent tubing from Mark Williams, around $350 funny car style, and had a local chassis guy cut the old cage off and fit and welded the new cage at a specific location and the chassis guy charged me $500 and did it in 2 days.
-
where to get some CM in socal ?
-
For a cage kit go here
https://neilparks.com/roll-bars.html or call up
-
Aircraft Spruce in Corona (right off the 91 at Autocenter dr.) open Sat @7am, then bring it to me for bending