FrontEngineDragsters.Org Forum

Technical => Spud Miller's Cave => Topic started by: captndiet on March 23, 2017, 12:55:31 PM

Title: Port Nozzle Design
Post by: captndiet on March 23, 2017, 12:55:31 PM

Anyone familiar with this port nozzle holder design?

The square cuts are on both sides and they vent up into where the nozzle screws in.

Jeff

Title: Re: Port Nozzle Design
Post by: BK on March 23, 2017, 04:08:10 PM

Pretty sure the slots are the air bleeds. Keeps dirt out that way.

Title: Re: Port Nozzle Design
Post by: captndiet on March 24, 2017, 06:21:21 PM

A normal aspirated nozzle holder would have the hole outside the the hat or port.

These would be pulling the air from inside the hat or port.

Jeff