1
Spud Miller's Cave / Pump flow and nozzle size
« on: May 05, 2013, 05:22:31 PM »
Hey Spud, I sent you two hilborn pumps after last season so you could check and flow them. I have lost the flow cards you sent back with the pumps. I remember they flowed around 6.5 gpm but I would like to know what rpm this flow was at.
Also I have some nozzles in my hilborn that some say are too big. They have 18BS stamped on them. It's a hilborn 3 piece 2-3/4, sbc 406 with iron eagle 23deg that flow pretty good.
Could this be too low of a pressure system?
Thanks
Also I have some nozzles in my hilborn that some say are too big. They have 18BS stamped on them. It's a hilborn 3 piece 2-3/4, sbc 406 with iron eagle 23deg that flow pretty good.
Could this be too low of a pressure system?
Thanks