FrontEngineDragsters.Org Forum

Technical => Roo Man's Room => Topic started by: 1Bad67 on June 11, 2013, 01:46:51 PM

Title: Question on narrowing an 8-3/4 Chrysler rearend
Post by: 1Bad67 on June 11, 2013, 01:46:51 PM

I'm going to be running a low power (pontiac 4 cylinder) FED. What are others doing when they narrow the rearend? Use the stock Chrysler bearing ends? or go with something aftermarket?

Title: Re: Question on narrowing an 8-3/4 Chrysler rearend
Post by: rooman on June 11, 2013, 04:14:35 PM

Back in the day everyone used Oldsmobile housing ends but more recently the Ford big bearing end seems to be the most popular.

Roo